If you are building Class 3 medical or aerospace, you need Rev H. If you are building simple Class 1 boards, Rev F remains functionally usable (though not technically "current"). Chapter 6: How to Reference IPC-A-610F in Your Work If you are writing a manufacturing procedure or Purchase Order, you must reference the standard correctly.
| Feature | Revision F (circa 2014) | Revision H (circa 2020) | | :--- | :--- | :--- | | | Basic criteria | Enhanced for flexible printed circuits (FPC). | | Rework Criteria | Limited coverage | Expanded "rework vs. repair" decision trees. | | Solder Slip (Bridging) | Simple definitions | High-res 3D imagery for micro-bridges. | | Ribbon Cables | Older methods | New criteria for folded contacts. | | Conformal Coating | Minimal | Detailed bubble and de-wetting photos. | ipc-a-610f pdf
| Class | Description | Example Products | | :--- | :--- | :--- | | | General Electronic Products | Toys, flashlights, consumer gadgets (where function is primary, longevity is secondary). | | Class 2 | Dedicated Service Electronic Products | Televisions, laptops, communication equipment (requires extended life but not critical failure). | | Class 3 | High Performance / Harsh Environment | Medical implants, aerospace avionics, military equipment (must be 100% functional under stress). | If you are building Class 3 medical or
A: Typically 416 pages (depending on the printer and appendix inclusion). | Feature | Revision F (circa 2014) |
A: If you purchased a single-user license from IPC, you can print one hard copy for internal use. You cannot mass-print it for your entire factory.
Introduction: The "Acceptability" Bible of Electronics In the world of printed circuit board assembly and electronics manufacturing, there is one document that sits on every process engineer’s desk and quality inspector’s shelf: IPC-A-610 . Officially titled "Acceptability of Electronic Assemblies," this standard is the most widely used inspection document in the electronics industry.